Beper 50.451 Betriebsanleitung Seite 8

Cyclonic Vacuum Cleaner Use instructions
Before cleaning, always unplug the appliance.
To protect against electric shock, do not immerse cord, plug or any
parts of the appliance into water or other fluids.
Do not hold the appliance with wet hands or feet.
Do not hold the appliance with naked feet.
Do not expose the appliance to atmospheric agents such as rain,
wind, snow, hail.
Do not use the appliance near explosives, highly flammable mate-
rials, gases, burning flames, heaters.
Do not allow children, disabled people or every people without expe-
rience or technical ability to use the appliance if they are not properly
watched over. Close supervision is necessary when any appliance
used by or near children.
Make sure that children do not play with this appliance.
If you decide not to use the appliance any longer, make it unservice-
able by simply cutting the supply cable after disconnecting the plug
from the socket.
ALSO MAKE ANY DANGEROUS PARTS UNSERVICE-
ABLE, ESPECIALLY FOR CHILDREN WHO COULD
PLAY WITH THE APPLIANCE.
COMPONENTS Fig.1
1. Handle
2. Hanging hole
3. Power cord winding hook
4. On/Off switch
5. Electric motor
6. Dust container
7. Hepa filter
8. Floor brush
HOW TO OPERATER YOUR VACUUM CLEANER
1. Hold the vacuum cleaner firmly with your hand on the handle.
Open the dust cup to see whether the filter is good.
2. Push the ON/OFF Power Switch to "ON" position.
3. Start vacuuming.
CAUTION: Make sure that you hold vacuum cleaner firmly.
otherwise it can slip out of you hand and cause injury.
CLEANING
The filters are subject to a natural deposit of dirt which decreases the suction considerably. It is important to keep
them clean in order to improve the efficiency and the life of the vacuum cleaner.
Before doing the following operations, be sure that the vacuum cleaner is turned off (the switch is pushed into
the "0" position) and that the power cord is unplug from the oulet.
When the dust container is full, please empty it.
8