Atus DP6000 Bedienungsanleitung Seite 13

DP6000 Paging Receivers | Instructions for Use
NOTE
: The 'out-of-range' function is only available if installed in your system.
•
Visual display: Alphanumeric display shows a flashing 'out-of-range' icon. Numeric display only version:
shows the following: '0-0-0' followed by '-0-0-' flashing.
•
Emits a bleep pattern for approx. 1 minute.This bleep can be reset by pressing the RESET/RECALL
button.
RESET
To the 'out-of-range' condition proceed as follows:
•
Bring the receiver back into range of the system.
•
If not brought back in range within 30 minutes the receiver emits a loud continuous warning bleep
(approx 1 second) and switches OFF automatically. Once the receiver has been automatically switched
OFF, it can be switched ON again by placing the 3-position switch to ON from OFF or by placing the
receiver into its charging/storage rack (except single storage rack LBB 6152/00).
Atus B.V. | 2013 - 44
ENG| 13
LBB 609x - LBB 619x