Inhaltsverzeichnis
Werbung
i
nStallation
Upon receiving the Ohaus Orbital/Microplate Shaker, check to ensure that no damage
has occurred during shipment. It is important that any damage that occurred in
transport is detected at the time of unpacking. If you do find such damage the carrier
must be notified immediately.
After unpacking, place the Orbital/Microplate Shaker on a level bench or table,
away from explosive vapors. Secure to an immovable work surface by pressing down
on the four (4) corners of the unit, creating a strong suction to the work surface (DO
NOT place on a bench mat). Ensure that the surface on which the unit is placed will
withstand typical heat produced by the unit. Always place the unit on a sturdy work
surface.
The Orbital/Microplate Shaker is supplied with a power cord that is inserted into
the IEC connector on the back of the unit first, then it can be plugged into a properly
grounded outlet. The 120V unit plugs into a 120 volt, 50/60 Hz source. The 230V unit
plugs into a 230 volt, 50/60 Hz source.
m
& S
aintenance
ervicing
The Orbital/Microplate Shaker is built for long, trouble-free, dependable service. No
lubrication or other technical user maintenance is required. However at least every
three (3) months you should:
• Unplug the unit.
• Remove any accumulated dirt from the base and tray.
• Check all accessible items to make sure they are properly tightened.
The unit should be given the care normally required for any electrical appliance. Avoid
wetting or unnecessary exposure to fumes. Spills should be removed promptly. DO
NOT use a cleaning agent or solvent on the front panel which is abrasive or harmful to
plastics, nor one which is flammable. Always ensure the power is disconnected from
the unit prior to any cleaning. If the unit ever requires service, contact your Ohaus
representative.
e
c
nvironmental
onDitionS
Operating Conditions: Indoor use only.
*For use in CO2 environments, incubators or cold rooms.
*Temperature: -10 to 60°C (14 to 140°F)
Humidity:
maximum 80% relative humidity, non-condensing
Altitude:
0 to 6,562 ft (2000 M) above sea level
Non-Operating Storage:
*Temperature: -20 to 65°C (-4 to 149°F)
Humidity:
maximum 80% relative humidity, non-condensing
Installation Category II and Pollution Degree 2 in accordance with IEC 664.
* Avoid cold starts: Unit is not designed to start after being in a cold room environment.
Bring unit into cold room from a room temperature environment, operate and remove
unit from cold room as soon as operation is complete.
e
D
quiPment
iSPoSal
This equipment must not be disposed of with unsorted waste. It is your responsibility to
correctly dispose of the equipment at life-cycle-end by handing it over
to an authorized facility for separate collection and recycling. It is also
your responsibility to decontaminate the equipment in case of biological,
chemical and/or radiological contamination, so as to protect the persons
involved in the disposal and recycling of the equipment from health
hazards.
For more information about where you can drop off your waste of equipment, please
contact your local dealer from whom you originally purchased this equipment. By doing
so, you will help to conserve natural and environmental resources and you will ensure that
your equipment is recycled in a manner that protects human health.
EN
2
Werbung
Inhaltsverzeichnis
