Inhaltsverzeichnis
Werbung
t
roubleShooting
During operation, any rattling or ticking sounds may indicate a loose screw on the tray,
a tray attachment or an accessory. All accessories should be sufficiently tightened in
place before starting the unit.
Error Code
Software Test
E04
unit overloaded
Press the standby button to clear this error. Be sure the load is within the maximum
load capacity before restarting the unit. If the E04 error persists, switch the unit off and
contact your Ohaus representative for repairs.
Error Code
Software Test
E03
drive system failure
Press the standby button to clear this error and remove the mechanical obstruction. If
the E03 error persists the reason may be a ceased bearing or broken drive belt and
should NOT be addressed by the end user. Switch the unit off and contact your Ohaus
representative for repairs.
*In the event a foot (suction cup) has come loose from the bench top, the unit will
register an errant E04 or E03 error message due to the instability of the unit. Press the
standby button to clear this error. Firmly press down on the four (4) corners of the unit,
creating a strong suction to the work surface (DO NOT place on bench mat). Press the
standby button to resume operation.
Cause
maximum load exceeded
loose foot (suction cup)*
Cause
ceased bearing
drive belt broken
mechanical obstruction
loose foot (suction cup)*
EN
11
Werbung
Inhaltsverzeichnis
