Troubleshooting - Lanaform New Vapolux Bedienungsanleitung

Care
EN
We recommend:
1) Using clean, fresh, distilled or demineralised water each time it is used.
2) Cleaning the reservoir every 2 days and cleaning the transducer every week.
3) Cleaning the device (see explanations below) and making sure that all its parts are completely dry when it is not in
use.
To clean the transducer (white ceramic ring (item i, Figure 3)):
1) Put 2 to 5 drops of vinegar on its surface and leave them there for 2 to 5 minutes.
2) Brush the foam off the surface with a soft brush. Do not use a hard tool to scrape the surface.
3) Rinse the reservoir of the base in clean water.
4) Do not use soap, solvent or spray cleaner to clean the transducer.
To clean the water basin:
1) Clean the basin with water using a soft cloth and vinegar if there is foam or limescale deposits on the inside.
2) Rinse the basin in clean water.
To clean the cool mist emission nozzle of the device:
1) Clean this with a brush or damp cloth.
2) Rinse the nozzle in clean water.
Storage
Having cleaned and dried the device, store it in a dry, cool place out of the reach of children.

TROUBLESHOOTING

In the event of a malfunction, under normal conditions of use, please refer to the following chart:
Effects
No steam, no light showing.
8
Possible causes
If there is no light.
The water level in the reservoir is too
low.
Water is leaking from the reservoir.
The temperature of the unit is too low.
Solutions
Check that the device is
connected and no breakdown
has occurred in that area.
Add water to the reservoir.
Check that the reservoir is in the
right position.
Place the unit in a room at
ambient temperature for half an
hour prior to use.