After Treatment Using The Device; Maintenance And Cleaning; Cleaning The Device; Replacing The Cartridge - Beurer IPL7000 Gebrauchsanweisung

6.4 After treatment using the device

1. When you have completed the hair removal session, hold and press the ON/OFF/power
selection button for 3 seconds. The device is in stand-by mode when the the small, green
indicator lamp flashes.
2. Remove the mains adapter from the mains socket.
3. After each hair removal session, it is recommended that you clean the device, in particular
the light area (see "Maintenance and cleaning").
4. After cleaning, it is recommended that you store the device in its original box and keep
it away from water.
5. After treatments, do not use any antiperspirants/deodorants as these may cause skin
irritation.

7. Maintenance and cleaning

7.1 Cleaning the device

After each hair removal session it is recommended that you clean your device, paying par-
ticular attention to the light area.
When cleaning, do not use any solvents or other aggressive or abrasive cleaning
agents, as the surface may become damaged.
Never immerse the device or any of its parts in water!
1. Before cleaning, remove the mains adapter of the device from the socket.
2. Clean the housing of the device with a dry, clean cloth.
3. Gently clean the light area and skin contact sensor using a slightly
damp, lint-free cloth.

7.2 Replacing the cartridge

The cartridge has a life cycle of up to 100,000 light pulses, which is sufficient for up to
26 years for normal use (one user, full body treatment including legs, arms, armpits, bikini
zone and face). This means that the cartridge for this model does not usually need to be
replaced.
If the indicator lamp flashes red, the lamp has reached 90% of its service life.
Note
The cartridge should only be replaced if there are large spots visible or if the lens is broken.
If this is the case, please contact beurer Customer Services.

8. What if there are problems?

"The device will not switch on"
• Ensure that the mains cable is correctly connected to the device.
• Ensure that the mains adapter is inserted into a wall socket.
37