Beper 50.450 Betriebsanleitung Seite 10

2in1 Cyclonic Vacuum Cleaner Use instructions
2-Empty the filter from the dust
3-Empty the dust from the dust cup container
4.Rinse the dust cup filter in WARM water, and then let it air dry COMPLETELY for 24 hours before replacing it
back in the dust cup container.
Important Note: DO NOT use a washing machine to clean the dust cup filter. Do not use a hair dryer to dry it. It
should, however, be replaced every three months (depending on usage) to ensure peak performance of your
vacuum.
5-Replace the dust cup filter carefully into the dust cup compartment. NEVER operate the HANDHELD vac
without the dust cup filter in place.
6 Attach the dust cup container to the main body of the unit.
TO INSERT THE DUST CUP FILTER: Fig.E
-Insert the dust cup filter within the dust cup container
- Screw the dust cup container being sure that the hooks are inserted in the dust container
-To insert the cover, go on being sure that the line of the dust container must be in the same position of the
symbol (lucchetto aperto). Screw the cover in correspondence to the symbol
-To remove the cover, unscrew the cover towards the symbol
TECNICHAL DATA:
Power: 600 W
Power supply: 220-240V ~ 50/60Hz
For any improvement reasons, Beper reserves the right to modify or improve the product without any
notice.
The European directive 2011/65/EU on Waste Electrical and Electronic Equipment (WEEE), requires
that old household electrical appliances must not be disposed of in the normal unsorted municipal
waste stream. Old appliances must be collected separately in order to optimize the recovery and
recycling of the materials they contain, and reduce the impact on human health and the environment.
The crossed out "wheeled bin" symbol on the product reminds you of your obligation, that when you
dispose of the appliance, it must be separately collected.
and lift it
10
10