Axis P3346-VE Installationsanleitung Seite 15

AXIS P3343-VE/P3344-VE/P3346-VE Installation Guide
Adjust the Lens
Open the Live View page in the web interface and make the following adjustments to the camera:
1. Loosen the locking screw and tilt adjustment screws.
2. Turn the lens (with the lens holder) to the desired position. Make sure the horizontal lines on
either side of the lens are aligned horizontally
Note:
Ensure that the mark on the lens cover, between the horizontal lines, is facing up.
3. Once satisfied, gently tighten the locking screw and tilt adjustment screws to secure the
camera's position.
4. Open the Focus Adjustment page in the Web interface under Setup > Focus & Zoom, and
follow the on-screen instructions. Use the image window to adjust the focus and zoom.
Go to Setup > Video & Image > Advanced in your web interface and see the online help for
more information.
Note:
Due to the dome's refraction, the image may appear slightly out of focus once the dome has been
placed. To correct this go to the Focus Adjustment page in the Web interface under
Setup > Focus & Zoom, and adjust the focus again.
Warning!
Adjusting the focus and zoom manually can damage the lens.
Horizontal line
Tilt adjustment screw
Locking screw
Tilt adjustment screw
Page 15