USRobotics 9113 Installationsanleitung Seite 16

English
If you still have trouble using the gateway, see the "Troubleshooting" section of
the User Guide on the USRobotics Installation CD-ROM.
EasyConfigurator was unable to detect my Internet connection.
Solution:
1. Go the the
Internet
Select your country and service provider. If your service provider is not
listed, select
Other
information. You may need some of the following information from your
ISP:
" VPI/VCI values
" ADSL standard (modulation)
" Encapsulation mode
" Protocol type
" Authentication (PAP or CHAP) for PPP connections
" IP address, your user name and password (if assigned by your ISP)
" Subnet mask, gateway, and DNS server information
2. If you are unsure about any required connection information, contact your
ISP.
3. Click .
Save
I am no longer able to access the Internet.
S o l u t i o n :
1. Press the
Reset
your gateway. Wait for the gateway to completely reboot.
N o te : Pressing and holding the
gateway to the factory default settings.
2. Reboot your computer. Wait for the computer to completely reboot and try
to access the Internet.
3. If you still cannot access the Internet, see the "Troubleshooting" section of
the User Guide on the USRobotics Installation CD-ROM for extended trou-
bleshooting on this issue.
SecureEasySetup could not configure my wireless client.
Solution:
Press the SecureEasySetup button on the back of the gateway for one full sec-
ond, then verify that the SecureEasySetup LED on the front of the gateway
starts blinking before initiating SecureEasySetup in the client utility for your
wireless adapter.
12
page in EasyConfigurator.
for your country and manually enter your connection
button on the back of your gateway for 1 second to reboot
Reset
button for 7 seconds will restore your