USRobotics 9113 Installationsanleitung Seite 13

For instructions on printer installation for Windows Me and 98SE, Mac, and
Linux, see the User Guide on the USRobotics Installation CD-ROM.
Step One: Local Printer Installation
N o t e : If the printer has already been installed on every computer that will use
it on the network, skip to "Step Two: Get Your Print Server Informa-
tion" .
You need to install the drivers provided by the printer manufacturer on each
computer that will use the printer before connecting your printer to the Wireless
N
dx ADSL2+ Gateway.
1. Plug your USB printer into one of the USB ports on the computer.
2. Install the printer by following the installation instructions included with your
printer.
3. Print a test page to ensure that the printer is working properly.
4. Power off the printer.
Step Two: Get Your Print Server Information
1. Disconnect the printer from your computer and plug the thin rectangular end
of the USB cable into the
ADSL 1
2. Turn your printer on.
3. On your computer, start a Web browser.
4. In the location or address line type
access the gateway configuration pages.
5. Enter the user name and the password for your gateway and click
6. From the
Device
7. Enter the
Printer name
8. Write down the printer location address (example:
). You need the address to set up the printer on computers that
ers/My_Printer
you want to have access to the printer.
port on the Wireless
USB
USB
2 3 4
Secure
15VDC
Easy
Setup
Reset
menu, select
Printer Server.
and a
Comment
N
and press ENTER to
192.168.1.1
for the printer.
http://192.168.1.1:1631/print-
English
dx ADSL2+ Gateway.
.
OK
9