Summer Whirpool, Bubbling Spa & Shower Gebrauchsanleitung Seite 3

18866 LL Whirlpool Spa Shower IB Eng p3 CS5.pdf 1 27/05/2014 15:27
SET-UP & USE:
Pump:
Step 1: To release lid, push reservoir backwards (Fig A). Pull up back edge of lid to remove.
Step 2: Remove both battery doors (Fig B).
Step 3: Insert 2 new alkaline "D" batteries into each compartment, taking care to match the + and -
markings (Fig C). Replace compartment doors and secure with screws.
Step 4: Push lid firmly on to back of reservoir (Fig D) until you hear the clips engage on both sides.
Step 5: Pull front portion of reservoir forward to secure remaining clips (Fig E). Make sure the lid is
tight.
Bath:
Step 1: Push bubble track into channels in bath (Fig F).
Step 2: Insert tip of plastic hose in connector into hole in end of bubble track (Fig G).
Step 3: Starting at the bottom, insert connector into channel in the end of the bath and clip into
place (Fig H).
To Use:
Step 1: Remove lid or fill water through fill hole on top of lid. Fill water to max fill line (
in Figure I)
**
on outside of reservoir.
CAUTION: Do not carry filled reservoir by the lid. Always support the reservoir
from underneath.
Step 2: Place pump unit onto outside of tub (Figure J).
Shower: Press left button once to turn shower on and once more to turn off (Figure K).
Bubble: Press the right button once to turn the bubbles on and twice more to turn off (Figure L).
Whirlpool: Press the right button twice to turn the whirlpool on and once more to turn off.
To Assemble Bath Sling:
Step 1: Insert lower part of frame into bottom part of sling (without headrest) (Figure M), pull the
other end of the sling up, engage the clip on the frame (Figure N), and then pull the rest of the sling
over the frame.
Step 2: Place elastic bands on side of sling onto plastic frame notches (Figure O).
To Remove Excess Water:
Step 1: Remove pump unit from the bath.
Step 2: Drain all water out of the bath by opening drain plug.
Step 3: Remove bubble tracks from the bath.
Step 4: Stand tub on end. (Note: Make sure to stand on end with drain plug).