Work Safety Introductions; Limitation Of Use; Operations Elements - Fisherbrand 15249805 Gebrauchsanweisung

1 - Introduction
The Fisherbrand Motorized Pipette aid is a device pipetting liquids
with the use of measuring pipettes. It can work with all types of glass
or plastic pipettes in the volume rang from 0.1 mL to 100 mL.
The Fisherbrand Motorized Pipette is a general purpose laboratory
device use to transfer or measure for pipetting safely and accurately.

2 - Work Safety Introductions

Before starting the work with the Fisherbrand Motorized Pipette
every user should read these operating instructions carefully. Using
the deceive inconsistently with the operating instructions may result
in damaging the device.The device should be maintenance only at an
authorized service center otherwise the manufacturer will be relieved
from any liability under the warranty.
During the work with the Fisherbrand Motorized Pipette general
safety regulations regarding risked related with laboratory work
should be observed. Protective clothing, goggles and gloves should
be worn.
• The Fisherbrand Motorized Pipette shall be used only for
measuring liquids in conditions speciied by the manufacture,
which are limited due to the chemical and mechanical resistance
the device as well as the user safety.
• The pipetting aid should not be used in an environment where
explosion risk is present.
• The information and instructions provided by the manufactures
of the reagents must be observed.
• Only original spare parts and accessories, recommended by the
manufacturer shall be used.
• Only the original charger, supplier by the manufacture, shall be
used for charging the lithium battery.
• In case of incorrect functioning of the pipetting aid, work shall be
used for charging the lithium battery.
• In case of incorrect functioning of the pipetting aid, work shall
be stopped. The device shall be cleaned in accordance with
the operating instructions and or sent to an authorized service
center.
• In the case of mechanical damage to the casing the device shall
be immediately be sent for repair to an authorized service center.
• The use of excessive force during work shall be avoided.

3 - Limitation of Use

• The pipetting aid may not be used in an environment where
explosion risk is present. Flammable liquid shall not be measured
in particular substances with lash point below 3°C. (either,
acetone.)
• The pipetting aid shall not be used for drawing acids with a
concentration above 1 mol.
• The pipetting aid shall not be used for drawing solutions with the
temperature above 50 °C.
• The pipetting aid may work in temperature range from +10°C. to
+35°C.

4 - Operations Elements

Assembly
• Grip the lithium battery plug by the wire, conirm alignment of
the plug and insert it in the socket. Push it irmly into the socket
until you can hear it snap into place. Place lithium battery in
compartment.
• Select lithium battery compartment cover.
• Close the lithium battery compartment.
• Recharging the lithium battery charging time is 2 hours.
Wall Support/ Invert Bench placement Mounting the wall support
The wall support is attached with snap tapes to permit easy removal
for cleaning purposes. To use the snap tapes, the mounting surface
must be smooth, clean and grease free. Prepare the surface for
mounting by cleaning with a 50% solution of isopropanol/water.
Alternatively, the wall support can be attached to the wall with two
screws.
www.eu.fishersci.com/fisherbrand
a) Smoothly rounded
b) With ridges for resting the instrument inverted on
the bench
5