Important Recommendations - S&P HV-150 A Bedienungsanleitung

ENGLISH
HV-150 M / AE / A
Please read these instructions carefully before using the product in order to avoid damage or any
dangerous situations arising. Any use of the product other than that indicated in this manual may
cause fire, electrical danger, or injury and will make the warranty null and void.
The warranty does not cover any defect, deterioration, loss, injury, or damage that is due to incorrect use of
the product. All legal rights in this regard are guaranteed. No warranty condition can exclude or change the
warranty conditions regulated by State laws that may not be excluded or modified for any reason.
- All appliances are supplied in perfect condition and operation. However if found to be defective the unit
should be returned to the supplier in accordance with
Should any defects or damage be found, do not install or attempt to repair the equipment, but contact the
dealer.
Do not leave the packaging within reach of children and dispose of the parts in compliance with current
provisions.
FlTTlNG AND WlRlNG INSTRUCTIONS

Important recommendations

Before installing the device or performing any maintenance, make sure all the safety instructions listed below,
will be fully met:
- The installation must be in accordance with the electrical standards and regulations in force in your country
and by qualified personnel.
- The HV range is designed to be installed in windows and walls.
- To prevent a return into the gas room, from the evacuation tube of gas appliance or other gas appliances
that burn fuel, it must prevent and ensure that the air inlets are sufficient and not obstructed.
- Do not use these products for explosive or corrosive environments.
- Ensure that the voltage and frequency of the mains are compatible with the values indicated in the
nameplate of the device.
- The electrical installation must include a double pole switch that has an opening distance between
contacts of at least 3mm.
- The HV series fans are class II (double electrical insulation), so there is no need to connect to an earth
connection.
- This product is designed for use in places where the ambient temperature does not exceed +45ºC.
-
-
-
- The installer must provide access to the fan to facilitate future maintenance and ensure it is properly fixed
and installed.
- The motor of HV-150N models incorporate a thermal fuse.
- Ensure that the arm of the shutter is in the same slot when the external grille is mounted. Check the correct
operation of the shutter mechanism.
10
the terms of the S&P guarantee.