BEARWARE 302653 Bedienungsanleitung Seite 35

9. Switching on and off manually
You can manually switch on and switch off the device connected to the timer
using the button with hand symbol or enable the automatic control according to
the configured timer programs again.
Press the button to change between the different modes. The display changes
between "AUTO", "ON" and "OFF".
Please note that when changing from "ON" or "OFF" to "AUTO", the last timer
state is retained until one of the configured timer programmes triggers a change.
10. Random function
The random function allows timer operations to be delayed. The delay is random-
ly between 2 to 32 minutes.
Press the "WEEK" and "HOUR" buttons simultaneously to enable or disable the
random function. When the function is enabled, this is indicated by an unfilled
circle in the display.
11. Daylight saving time
Press the button "HOUR" and "MIN" simultaneously to toggle between summer
and winter time. If summer time is set, then a clock symbol is shown in the timer
display. In this case, the clock is put forward by one hour.
12. Safety instructions and disclaimer
Never try to open the device to carry out repairs or modifications. Avoid contact
with the mains voltage. Do not short-circuit the product. The device is not ap-
proved for outdoor use. Therefore please use it only in dry surroundings. Protect
it from high humidity, water and snow. Do not expose the device to high temper-
atures. Do not expose the device to sudden changes in temperature or strong
vibrations, as this could damage the electronic components. Check the device for
any damage before using it.
35
English