BEARWARE 302653 Bedienungsanleitung Seite 34

8. Setting the timer programs
Press the PROG button briefly. You can first set the time at which the connected
device has to be switched on (ON).
Press the WEEK button until the desired days of the week on which the timer
programme has to be executed are shown on the display. Now set the desired
time using the "HOUR" and "MIN" buttons.
Then press the PROG button again. You can then set the time at which the
connected device has to be switched off (OFF). Configure the time and days of the
week using the WEEK, HOUR, and MIN buttons as described in the previous step.
Note: Please remember that the days of the week for switching on and switching
off have to be configured separately. The selected combination is not automatical-
ly adopted for the entire timer programme.
Press the PROG button briefly. You can then configure the second timer program.
A total of 8 timer programs are available, which you can configure in this way.
Once all the programs have been customised as needed, please press the CLOCK
button. The display again shows the current time and the day of the week. The
timer is now ready for use.
Note: Please ensure that the times of the individual timer programmes do not over-
lap in order to avoid unintentional switching on or off.
To disable a timer programme again or to enable a disabled program, press the
PROG button until the desired program is shown in the display. You can now
enable or disable the timer program using the R button.
34
English