Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Lift the appliance using equipment fit to bear its weight. Separate the appliance from the wooden pallet and fit
the supplied legs into the housings on the base plate provided for the purpose (6 in Fig. 3).
Use a spirit level to ensure that the appliance is standing perfectly level. If necessary, adjust the legs.
5 INSTALLATION
5.1 CONNECTION DIAGRAM (Fig. 4)
7. electrical connection controlled by omnipolar circuit-breaker with residual current device
8. water tap
9. water supply pipe
10. water drainage pipe
5.2 POSITIONING
‼ The appliance must be installed in a hygienically clean location; it is advisable to avoid rooms like cellars and
store-rooms, because failure to meet hygiene requirements is likely to lead to the formation and proliferation
of bacteria in the appliance.
The appliance can operate at an ambient temperature of between 10°C and 43°C.
The best performance will be obtained by installing the appliance in a place with an ambient temperature of
between 10°C and 35°C and a water temperature of between 3°C and 25°C.
Avoid direct exposure to sunlight and do not install near heat sources.
‼ This appliance:
•
must be installed in a place where it can be supervised by skilled personnel.
•
must not be used outdoors.
•
must not be installed in damp places or where it is liable to be sprayed with water.
•
must not be cleaned with jets of water.
•
must be allowed a clearance of least 5 cm all around
5.3 CONNECTION TO THE WATER MAINS
‼ IMPORTANT:
•
The appliance must be connected to the water mains by professionally qualified personnel in accordance
with the Manufacturer's instructions.
•
This appliance must be only be supplied with cold water for human consumption (drinking water).
•
The operating pressure must be between 0.1 and 0.6 mpa.
•
A tap must be installed between the water mains and the feed pipe of the appliance, so that the water
supply may be shut off if necessary.
•
Where the feed water is particularly hard, you are advised to install a polyvalent cartridge filter. Any solid
particles (e.g. Sand) may be eliminated by installing a mechanical filter, which must be periodically inspected
and cleaned. These devices must comply with the standards in force in the Country of use.
•
Never turn the water supply tap off when the appliance is working.
•
Only new hose-sets supplied with the appliance are to be used to connect the appliance to water mains, old
hose-sets should not be reused.
5.3.a FILLING WITH WATER (Fig. 5)
Insert the special seals provided (12) in the two threaded ring nuts (11) of the water supply pipe (9) supplied
with the appliance.
Without exerting excessive force (otherwise the unions could crack), firmly tighten one of the threaded ring nuts
on the outlet of the solenoid valve located in the rear of the appliance. The other threaded ring nut must be
screwed to the water tap (8); this too must be provided with a thread.
9
Werbung
Inhaltsverzeichnis
