Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Mounting
•
Mount the transducer so that it is above the maximum material level by at least the
blanking value. Refer to the associated controller manual.
•
For liquid applications, the transducer must be mounted so that the axis of transmission is
perpendicular to the liquid surface.
•
For solids applications, use a Siemens Milltronics Easy Aimer to aim the transducer.
•
Where the transducer is mounted to a standpipe, the inner standpipe surface and end
must be smooth and free of burrs, ridges, and seams.
•
Consider the optional temperature sensor when mounting the transducer.
•
Do not overtighten mounting. Hand tightening of the mounting hardware is sufficient.
•
Do not mount the transducer directly to metal. Use a PVC coupling and nipple for isolation
(customer supplied).
Mounting – Solids Applications
Non-Corrosive Applications
In solids applications, mount the transducer so that it is aimed toward the low level draw point. Use
the optional Siemens Milltronics Easy Aimer to facilitate this mounting.
Page EN-8
ST-H Transducer – OPERATION MANUAL
Easy Aimer
(typical model)
WARNING!
NOT
for use in a
corrosive
environment.
transducer
7ML19985QK82
suitable
Werbung
Inhaltsverzeichnis
