Time Setting; Cleaning Modes - mamibot EXVAC660 Bedienungsanleitung

EN
Cleaning mode – the ON/OFF button is in the ON position, the vacuum robot operates.
Stand-by mode – the ON/OFF button is in the ON position, the vacuum robot does not operate. To activate it,
press any cleaning mode button.
Sleep mode – the ON/OFF button is in the ON position, the display panel is ON. The vacuum robot enters this
mode automatically after 3 seconds of inactivity.

TIME SETTING

Make sure that the vacuum robot is ON and not charging.
To set the time, press the button on the remote control. First two
digits begin to ash to set the time. To set the values, use the ˄ ˅ buttons.
Press the > button and set the minutes as described above.
CLEANING PLANNING
To set the cleaning mode, press the button on the remote control. At first, two digits begin to flash to set the
time. To set the values, use the ˄ ˅ buttons. Press the > button and set the minutes as described above. Confirm
the time by pressing the (ON/STOP button). The vacuum robot will vacuum each day at the time you have set.
To cancel the scheduled cleaning, press the scheduling button for 3s.
Warning: If you switch the ON/OFF button on the side of the vacuum robot to the OFF position, the scheduling
will be cancelled.

CLEANING MODES

Automatic mode
The vacuum robot uses advanced navigation to calculate the best way to achieve e ective cleaning. To activate
this mode, press the button on the vacuum robot body or on the remote control.
Edge cleaning path mode
To activate this mode, press the button on the remote control. The vacuum robot will vacuum along the
walls where the dust is most often. If you want to cancel this mode, press PAUSE.
88