Cleaning And Maintenance - mamibot EXVAC660 Bedienungsanleitung

EN

CLEANING AND MAINTENANCE

Battery
• Allow the battery to charge for more than 6 hours before first use.
• In case of low battery detection during cleaning, the vacuum robot automatically searches for the charging
base and starts to charge.
• If the appliance is being transported or it is not used for a long time, switch it OFF with the main switch.
• If you do not use the robotic vacuum robot for more than 3 months, allow it to charge for 12 hours, then turn
it OFF with the main switch and place it in a dry and cool place.
• It is highly recommended to use the charging base for charging.
• Remove the batteries from the remote control if you do not use the vacuum robot for a longer time.
• The vacuum robot is equipped with a special shield that stops supplying power and prevents overcharging.
This ensures its long service life and at the same time the vacuum robot is ready to start cleaning again.
Side brush
You can easily check the side brush condition and if necessary, remove the dirt.
• Turn the vacuum robot upside down.
• By pulling up from the robot's body, release the brush.
• Use scissors to remove hair and other dirt.
Side brush bristles can be damaged (frayed) during transport or by while
in unsuitable conditions. Inserting the bristles in hot water will straighten
them to their original state.
In case of damage to the side brushes, they can be replaced with a new one.
• Turn the vacuum robot upside down.
• By pulling up from the robot's body, release the brush.
• Remove the damaged brush and replace it with a new one.
Warning: Make sure the brush is placed on the right side of the vacuum
robot.
Replacement of side brushes may be performed by an authorized service
centre.
OK
90
renewable replacement
necessary