Accessories; Product / Product Group - Assa Abloy aperio C100 V3 Installations- Und Montageanleitung

Accessories

Approved 2017-08-16
Accessories

Product / product group

A type CR2 3 V lithium battery for the power supply of the electronics in the knob
cylinder is included in the scope of delivery of the electronic knob cylinder C100 V3.
A replacement battery can be ordered separately ("Maintenance", page 48):
CR2 lithium battery with min. 800 mAh
A special tool is required for battery replacement:
Battery replacement tool
The programming application tool with controller and USB dongle is not included
in the scope of delivery of the electronic knob cylinder C100 V3. The software can
be ordered separately:
PAP Software Set
PAP Software Set Aperio™ Offline
The following hubs are suitable for the electronic knob cylinder C100 V3:
Communication Hub RS485 Aperio™ Protocol
Radio DAC/DAC100
Communication Hub Wiegand simple
Communication Hub 1toS RS485
Communication Hub Wiegand advanced
Communication Hub IP (Internet Protocol)
The following knob cover is suitable for the electronic knob cylinder C100 V3 (inside
and outside knob):
Stainless steel cylinder knob cover
The knob can be equipped with a turning aid in order to facilitate turning for
disabled persons.
Turning aid
5 0 5 Z B – B A T T – – – 0 0
5 0 5 Z B – K – T O O L – – – 0 1
5 0 0 Z B – P A P U S B – 0 0
5 0 0 Z B – P A P U S B D 0 0
5 0 0 – – – – – – – 1 0 – 0 0
5 0 0 – – – – – – – 20 – 0 0
5 0 0 – – – – – – – 3 0 – 0 0
5 0 0 – – – – – – – 4 0 – 0 0
5 0 0 – – – – – – – 6 0 – 0 0
5 0 0 – – – – – – – 8 0 – 0 0
5 0 5 Z B – K C S T – – – 0 1
5 0 5 Z B – K C T A – – – 0 1
EN 47