Inhaltsverzeichnis
Werbung
1.
Safety Instructions
General
R5-rectifiers contain dangerous voltages which can cause death or serious injury.
Care should be taken to ensure correct and safe operation to minimise the risk
Danger to life
to personnel and equipment.
All work from the transport, to installation and start-up as well as maintenance
may only be done by qualified personnel (IEC 364 and/or CENELEC HD 384
and IEC-Report 664 and note national safety regulations). According to this
manual qualified staff means:
– those who are able to recognize and judge the possible dangers based on
their technical training and experience
– those with knowledge of the relevant standards and who are familiar with the
field of power transmission (VDE 0100, EN 50178, EN 60204 as well as the
approporiate regulations for your area).
Use as directed
R5-rectifiers are designed for the supply of frequency inverters with DC-input,
Only
respectively. Use for other purpose is not recommended and may lead to
Qualified
equipment damage.
Electro-
Personnel
The R5-rectifiers must not be started until it is determined that the installation
complies with 89/392/EEC (machine directive) as well as the EMC-directive (89/
336/EEC)(note EN60204).
The R5-rectifiers meet the requirements of the Low-Voltage Directive 73/231/
Observe
EEC. The harmonized standards of the series EN 50178 in conenction with EN
Standards
60439-1 and EN 60146 were used.
Transport, Storage and Installation
R5-rectifiers must be stored in the original packing and protected against
Protect
dampness and excessive coldness or warmth. The transportation over large
Against
distances must be done in the original packing and it must be secured against
Accidental
blows and shocks. Observe the marking on the outer packing! After removing
Contact
the packing place the R5-rectifiers securely on a stable base to proceed with the
installation.
Safety Instructions
GB - 5
Werbung
Inhaltsverzeichnis
