Removal of the pouch
5
•
Maintain the base plate by the prehension tab and unstick the pouch progressively with the other hand by pulling on the tab of the pouch (J).
•
For Urostomy pouch*, unstick the pouch either with the thumb inserted into the specific cut-out, or with the specific accessory inserted in the slot (J).
Turn to unstick the pouch. Complete the un-sticking progressively.
•
In order to be able to place a new pouch onto the base plate, the flange must be perfectly clean and dry.
Drainable pouches*
6
Drainable pouch with integrated Roll'Up clamp:
Closing the drainage sleeve :
•
Fold the sleeve four times using the guide and fold the tab back.(K3)
•
To seal the pouch, apply pressure on all the length of the two self-fastening strips facing each other.
Emptying of pouch :
•
Position yourself to carry out the drainage, release the two self-fastening strips and unroll the sleeve. Be careful, the drainage will start at this point.
To fully open the outlet place your fingers on each side and press slightly (K1).
•
Once the drainage is complete, expel, as much as possible, any matter still in the sleeve by pressing it lightly from top to bottom. Carefully clean its
extremity (be careful: use non-shedding material) (K2).
•
Then, close the pouch.
Please note: the closed sleeve is hidden under the soft backing material (K3).
Drainable pouch with cap, Maxi Drainable
•
Close the pouch with the cap included in the box
•
To empty your pouch, remove the cap and direct the opening of the pouch towards the toilet. Then, clean the end of the evacuation outlet with a
non-shedding material and close with the cap.
•
If it's necessary, the pouch can be connected to a higher capacity collecting pouch, Flow Collector.
Use a patch cover for filter protection (only for closed or drainable pouches)
7
Before a bath or a shower, deactivate the filter. Deactivate the filter using one of the adhesive patches included in the box. Take one and stick it on the
top of the pouch, middle or side depending on the type of bag used, so that the hole for gas evacuation is blocked ( L1 or L2).
* Availability may vary from one country to another.
Instructions for use
EN
- 4 -
- 4 -