Parameterisation For Commissionning - flamco ENA 7 Montage- Und Betriebsanleitung

Installation and
operating instructions
appendix
TP.03/24/09.EN Edition 2009 / EXP
14-1519 FLM ENA 7-30 INSTRUCTIE.indb 22 14-1519 FLM ENA 7-30 INSTRUCTIE.indb 22
ENA 7-30 INSTALLATION AND OPERATING INSTRUCTIONS_APPENDIX
1 Commissioning
1.1 Commissioning ENA 7-30
Before commissioning make sure that the unit and its items of equipment are in conformation with the
regulations that apply at the place of erection and in respect of the field of application. The party erection and
operating the unit will be responsible for making the checks and for carrying out commissioning.
For commissioning, the hydraulic and electric connections must be in place, and the shut-off devices open.
1.2 Parameterisation for commissioning
The ENA 7-30 comes with a pre- parameterized control. As this control offers a wide range of possibilities, you
will have to set operating parameters so that they will be adapted to the concrete operating conditions of your
heating/cooling system.
When the control is switched on, first 'ENA 7-30' and after that the start screen appears on the display. Now it
is possible to make a selection by turning and pressing the control knob.
Turn and press the control knob (on System, displayed against a black background) to get to the Selection
menu. Select 'Entries' (code 000001) to get to the Equipment, Parameter and Service menus for carrying out
parameterization. Set up the control point by point – refer to the sections with explanations on the Hardware,
Parameter and Service menu (ENA 7-30 – Installation and operating instructions).
Select 'Back' to return to or to complete menu items. For completely exiting submenus, you can also hold the
control knob in the pressed state, causing the control to invoke the Process screen/START menu.
On completing the parameterization of the control, confirm/press Start to get to the Process screen.
The ENA 7, 10, 20, or 30 will then commence its operation.
22
3
11-02-16 10:47 11-02-16 10:47