Cisco 200 Serie Kurzanleitung Seite 9

Back Panel
The power port is located on the back panel of the smart switch.
Returning the Device to the Factory
5
Default Settings
To use the Reset
following:
• To reboot the smart switch, press the
seconds.
• To restore the smart switch configuration to the factory default
settings:
1. Disconnect the smart switch from the network or disable all DHCP
servers on your network.
2. With the power on, press and hold the
10 seconds.
200 Series Smart Switches
button to reboot or reset the smart switch, do the
Reset button for less than 10
Reset button for more than
9