Absaar SL60 Benutzerhandbuch Seite 28

5/ Chargers can generate heat when they are charging. Please DO NOT cover the metal enclosures.
6/ Instructions for batteries as well as transport tools must be strictly followed at the time of charging.
7/ The battery must be connected or disconnected when the power is off.
8/ Maintenance on chargers must be performed by professionals.
9/ Fuses and replacement cables must be replaced by parts having the same specifications.
10/ Highly corrosive sulphuric acid, hydrogen and oxygen fumes may be generated when the batteries are charging.
Batteries must be charged indoors in a well-ventilated space. The product should be kept away from any flame or
spark. Please DO NOT smoke when the charger is in use.
11/ Never connect the battery clamps together.
12/ Battery lids must be removed before and during the charging process.
13/ It is strictly forbidden to reverse the connections of the battery clamps; Red on the positive (+) and black on the
negative (-) terminal of the battery.
14/ Please DO NOT use the charger for charging non-rechargeable batteries.
15/ When replacing the fuse, make sure that the new fuse complies with the manufacture's specifications. Please DO
NOT use other conductors to replace the fuse.
16/ If the power cord is damaged, it must be removed and replaced by a licensed professional.
4. INSTRUCTIONS FOR CHARGERS AND BATTERIES
To ensure the proper functioning of charger and battery and also to protect them against damages, please observe
the following rules:
4.1/ Battery use
- When the battery is not sufficiently charged, the voltage across it may be correct at approximately 12V or
24V depending on the battery model. The main physical phenomenon indicating sufficient or insufficient
battery charge is the gravity of the battery solution. Normally, when the gravity of the battery solution is
1.28kg/l, it means the battery is fully charged. If it is lower than 1.16kg/l, the battery is not fully charged.
- Before charging the battery and depending on its model, remove the cover to check the level of electrolyte
solution. If necessary, top up with deionised water.
- The electrolyte solutions in batteries are extremely corrosive. Please ensure it does not come in contact with
your skin or clothes. In case of contact with skin, rinse thoroughly with plenty of water and seek medical
advice immediately.
4.2/ Method for charging the battery
- Place the red cable on the 12V or 24V terminal of the charger depending on the desired voltage and tighten the nut
firmly.
28
UK