Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation
The SIPLUS Mounting Kit ET 200SP is intended for mounting on the standard mounting rail included in the scope of
delivery.
1. If necessary, shorten the standard mounting rail
2. Mount the standard mounting rail
3. If necessary, shorten the damping material
4. Mount the end brackets
contact with the SIPLUS ET 200SP system without a gap.
5. Glue the damping material
Make sure that the damping material does not rest on the end brackets.
6. Tighten 2 × 4 screws
7. Mount the C-section rail
⑤
8. Push the clip
of both end brackets into the C-section rail
9. Tighten the two screws
a
Pre-cut part of the C-section rail = total length - 52 mm
b
Pre-cut part of the damping material = C-section rail - 32 mm
c
Total length
Mounting Kit ET 200SP
A5E47207185B/001, 06/2019
⑧
.
②
⑦
⑨
and
of the SIPLUS Mounting Kit ET 200SP in such a way that the end brackets are in
②
centrally onto the C-section rail
⑥
with a torque of 2.5 Nm.
①
with the glued-on damping material
③
with a torque of 2.5 Nm.
⑧
and the C-section rail
according to the length of the C-section rail minus 32 mm.
①
.
②
.
①
up to the stop.
①
to the required length.
7
Werbung
