Operation - SOLAC AE2540 Gebrauchsanleitung

• Do not store or charge the appliance near radiators or other heat sources, or exposed
to direct sunlight.
• Do not charge the appliance in dirty or damp places and make sure the temperature is
between 0ºC and 37ºC.

OPERATION

)
This appliance has been specially designed to vacuum floors, carpets, furniture and
fabrics. Do not use it for other purposes.
n
Never vacuum live ash, splinters, sharp objects or liquids
n
Do not vacuum lit matches or cigarette butts. Do not vacuum toxic materials, such as
ammonium.
n
Before adding or removing accessories or performing any type of maintenance work,
unplug from the mains.
n
Do not use the appliance on top of the power cable.
)
Remove all transport and packaging materials fully.
1 Check that the dust collector (10) and the filters (12, 13, 14) are fitted properly. See the
next section (Cleaning and Maintenance).
2 Select the necessary accessory, depending on the purpose for which you are going to
use the broom
Upholstery nozzle (17)
Especially designed for sofas and other upholstered surfaces.
Suction nozzle for grooves and corners (18)
Designed to get into narrow areas, grooves and corners.
Multipurpose brush (19)
Suitable to vacuum all kinds of floors, carpets and rugs.
• Insert the multipurpose brush (19) in the suction outlet and push inwards until you hear
a click. To remove it, press lightly on the multipurpose brush release button (20) and
pull outwards. (fig. 3).
3 Adapt the broom size as necessary by adjusting the length of the telescopic pole (15)
(fig. 4). To do so:
• Slide the handle release button (5) in the direction shown in the figure and pull the
handle (4) in the opposite direction to extend the pole.
• Release the release button (5) when you have reached the desired length in order to
lock the telescopic pole.
• To shrink the telescopic pole, slide the handle release button (5) in the direction shown
in the figure and push the handle inside the main broom body.
• Release the release button (5) once you have finished.
4 Place the switch (3) in the ON position. The LED (2) will change to blue.
)
If during operation you hear a high-pitched whistle, different to the normal noise that
the appliance makes, switch off and unplug the appliance. Check that the air inlets and
outlets and the filters are not blocked. If they are blocked, unblock them.
5 Once you have finished vacuuming, switch off the appliance by placing the switch (3)
in the OFF position. The LED (2) will switch off.
6 Empty the dust collector (10). See the next section (Cleaning and Maintenance).
12
(fig. 2)
. Fit the accessory in the suction outlet (9).
OPERATION