Replacing The Pump - Swim & Fun 1561 Handbuch

7.

Replacing the pump

Isolate the power supply and remove
the pump housing from the pool.
Unscrew the filter by taking hold of
the bottom plastic edge and turning it
anti clockwise until the filter is loose
from the black mounting plate.
Locate the filter and the motor in the
pump housing so that the notches on
the edge of the mounting plate fit the
edge of the pump housing.
34
Undo the black mounting plate
by pushing it in and turning it anti
clockwise. IMPORTANT: Do not take
hold of the motor. It will destroy
the spring inside.
The mounting plate is now ready for
a new filter.
Fasten the black mounting plate by
pushing it in and turning it clockwise.
IMPORTANT: Do not take hold of
the motor. It will destroy the spring
inside.
Lift the motor and filter out of the
pump housing.
Screw the filter onto the mounting
plate, by turning it clockwise.
MV-1561-11-2017 . © All rights reserved Swim & Fun Scandinavia ApS
UK