Cleaning And Maintenance - Swim & Fun 1561 Handbuch

UK
Plug the pump into a power socket.
The filter in operation
The filter now runs in a normal filter routine. Continue to filter the pool water, until it is clear and clean.
The filter must run a minimum of 2 x 4 hours daily so that the water will be filtered twice a day. Be-
tween each interval the pump will be idle for a few hours. Connect a timer if necessary. In periods
of hot weather and when there is a lot of bathing activity, the filter time must be increased, as does
the need for water care products.
When the filter is clean, the pump has a maximum effect. On the other hand, if the filter is clogged
with accumulated dirt, the water will not be able to circulate properly. Remember to inspect the filter
as soon as the flow decreases, or each time the pump has been running for 5 hours – depending
on whichever comes first. If the filter looks dirty – it should always be cleaned!
6.

Cleaning and maintenance

1. Isolate the power source
2. Remove the filter (lift the filter cover and unscrew the filter cartridge).
3. Rinse the filter with a garden hose or under the tap. The filter can also be cleaned in a dish-
washer. Rinse both the inside and the outside. Additional cleaning can be done by rinsing
the filter in hot soapy water. If there are small calcium deposits in the filter layers, it no longer
cleans effectively, and must therefore be replaced with a new filter. The filter is clogged with
algae and dirt, so use an extra powerful water jet for cleaning. Never let the filter dry out, as it
makes the filter difficult to clean and destroys it. Always have a spare filter ready for use.
4. Put the filter back into the skimmer. Carefully tighten the screws and close the filter.
5. Turn on the power source and continue the filtering.
YOU MUST KEEP THE FILTER CLEAN AT ALL TIMES IN ORDER
TO MAINTAIN THE CORRECT WATER FLOW IN THE POOL!
Only use the filter that fits this pool. The filter must be covered with water at all times,
otherwise there is a risk of damage to the pump.
Never add chemicals directly into the skimmer. These should instead be dissolved in
a bucket of water, before being added along the edge of the pool. Alternatively use a
child-proof floating chlorine dispenser.
See more about water care and pool accessories at your local pool distributor, or click
on www.swim-fun.com
MV-1561-11-2017 . © All rights reserved Swim & Fun Scandinavia ApS
33