Velleman EDA5001 Bedienungsanleitung Seite 5

7. Operation
Note: prior to using the BTSP2 for the first time, both headset and
base station should be charged fully (see §8).
Consider charging base station and headset separately; when
charging the headset through the base station, the latter will
get priority and will be charged first.
• To switch the base station on, place the ear device [A] into the
base station. Make sure the USB connectors [A1] and [G] are
securely fit. Press and hold the function key [A2] for ±6 seconds.
The LCD display [E] shows 888888888888, followed by ON.
• To use the ear device [A] stand-alone, remove it from the base
station and press and hold the function key for ± 6 seconds. The
base station remains off.
• Adjust the volume of the ear device [A], using the volume up
[6] and volume down [7] buttons. Adjust the volume of the base
station speaker [B] by turning the volume knob [C].
• Switch the car kit off by pressing and holding the function key
[A2] for ±8 seconds. The LCD display [E] shows OFF.
pairing
The device must be associated with a Bluetooth
phone before use.
• Press and hold the function key [A2] until the status indicator
[A3] flashes red and blue.
• Enable the Bluetooth
• On the mobile phone, select BTSP2 and enter the password
(0000) to confirm pairing.
• The base station displays CONNECTED and the status indicator
[A3] flashes blue with a 5 seconds interval.
• Note that some mobile phones will not connect until a call is
received or made.
voice dialling
Voice dialling requires a mobile phone that supports this function.
• Verify that the status indicator [A3] flashes blue (interval 5s).
• Press the function key [A2] once. The display shows
VOICEDIAL and a voice dialling prompt is sent.
• Respond with a pre-recorded voice tag. The base station repeats
the voice tag and the number is dialled.
00 (07/04/2009)
BTSP2
®
function on the mobile phone (not incl.).
5
®
compatible mobile
Velleman
®