Nikko Air RACE VISION 220 FPV Bedienungsanleitung Seite 16

SYNC CONTROLLER TO SIMULATOR :
DE
1. Using the USB charging cord, plug the USB into the computer and insert the charging port to the drone.
2. Turn on the power of the drone and the controller.
3. Arm the drone. Push "B" for 5 seconds until the rear lights of the drone turn green and fade on and o .
4. Follow the instructions in the simulator to nish setup.
5. To switch back to ying mode push "B" for 5 seconds until the rear lights of drone are blinking.
SYNC CONTROLLER TO SIMULATOR :
ES
1. Using the USB charging cord, plug the USB into the computer and insert the charging port to the drone.
2. Turn on the power of the drone and the controller.
3. Arm the drone. Push "B" for 5 seconds until the rear lights of the drone turn green and fade on and o .
4. Follow the instructions in the simulator to nish setup.
5. To switch back to ying mode push "B" for 5 seconds until the rear lights of drone are blinking.
SYNC CONTROLLER TO SIMULATOR :
IT
1. Using the USB charging cord, plug the USB into the computer and insert the charging port to the drone.
2. Turn on the power of the drone and the controller.
3. Arm the drone. Push "B" for 5 seconds until the rear lights of the drone turn green and fade on and o .
4. Follow the instructions in the simulator to nish setup.
5. To switch back to ying mode push "B" for 5 seconds until the rear lights of drone are blinking.
SYNC CONTROLLER TO SIMULATOR :
PT
1. Using the USB charging cord, plug the USB into the computer and insert the charging port to the drone.
2. Turn on the power of the drone and the controller.
3. Arm the drone. Push "B" for 5 seconds until the rear lights of the drone turn green and fade on and o .
4. Follow the instructions in the simulator to nish setup.
5. To switch back to ying mode push "B" for 5 seconds until the rear lights of drone are blinking.
SYNC CONTROLLER TO SIMULATOR :
NL
1. Using the USB charging cord, plug the USB into the computer and insert the charging port to the drone.
2. Turn on the power of the drone and the controller.
3. Arm the drone. Push "B" for 5 seconds until the rear lights of the drone turn green and fade on and o .
4. Follow the instructions in the simulator to nish setup.
5. To switch back to ying mode push "B" for 5 seconds until the rear lights of drone are blinking.
SYNC CONTROLLER TO SIMULATOR :
PL
1. Using the USB charging cord, plug the USB into the computer and insert the charging port to the drone.
2. Turn on the power of the drone and the controller.
3. Arm the drone. Push "B" for 5 seconds until the rear lights of the drone turn green and fade on and o .
4. Follow the instructions in the simulator to nish setup.
5. To switch back to ying mode push "B" for 5 seconds until the rear lights of drone are blinking.
16