Important Instructions; Technical Data - EINHELL LE-AK 12/250 Bedienungsanleitung

Anleitung LE-AK 12-250
GB
Please read this manual carefully and pay attention
to the information provided. Use this manual to
familiarize yourself with the machine, its correct use
and safety regulations.

1. Important instructions!

Never clean your clothes with the compressed air.
Never direct the compressed air at other persons.
Keep all the ventilation slots clean.
Take care not to draw in dust or similar
contaminants with the compressor.
Protect the compressor from the rain, splashing
water and damp surroundings.
Do not stand the compressor on heated surfaces.
Do not use the cable for any purpose other than
that intended!
Never carry the compressor by its cable and never
pull the plug out of the cigarette lighter socket by
the cable. Protect the cable from heat, oil and
sharp edges.
Examine the machine for signs of damage.
Unless otherwise instructed by this manual, have
defective or damaged parts repaired or replaced
by a customer service workshop.
Operate only from a rated voltage of 12 volts
(direct voltage). Higher voltage ratings will destroy
the compressor.
Make sure there is reliable contact between the
socket-outlet and the plug. Poor contact will lead to
overheating and risk of fire.
The compressor is not suitable for permanent
duty.
Ensure that the compressor cools down for 10
minutes after it has run for 30 minutes.
4
30.04.2004 11:12 Uhr

2. Technical data

Power supply: 12V, from a cigarette lighter
socket or an Einhell Power Station
Pumping capacity:
Length of connection cable:
Length of air hose:
Check pressure gauge:
Operating time:
3. Before putting the compressor into
operation
You can use the quick-release valve either directly or
in conjunction with one of the additional adapters,
depending on which type of valve is fitted to the item
you want to inflate.
To fit one of the additional adapters, proceed as
follows:
1. Arrange the clip of the quick-release valve so that
it points vertically up.
2. Now insert the adapter of your choice in the quick-
release valve.
3. Press down the clip in order to fasten the adapter
in the quick-release valve.
If you want to use the quick-release valve without an
adapter, plug the quick-release valve (clip open) over
the valve on the item you want to inflate
(see Figure 1).
Then press down the clip in order to fasten the quick-
release valve in place (see Figure 2).
1 2
Seite 4
max. 10 bar
approx. 2,9 m
approx. 0.45 m
0 - 10 bar
max. 10 minutes