Kathrein BAS 60 Bedienungsanleitung Seite 16

7. Connecting the cable
7.1 Connecting the cable to the antenna
(Abb. 7)
1. Loosen the two milled screws and remove the LNB
cover.
2. Connect the F-plug as shown.
3. Connect the cable to the LNB.
4. Now press the cable (outer diameter 6.8 mm) into
the cable support. If you use the thinner cable
(e.g. for Sat jointed masts HDM xxx with integrated
cables), fi rst put the supplied sleeve on the cable in
order to compensate the diameter.
5. Replace the LNB cover.
7.2 Connecting the cable to the receiver
(Fig. 8)
• Mount a F-connector to the end of the cable pointing
to the receiver. Cable and connector preparation
according to Fig. 7.
Note:
If the receiver is an older model; it may be necessary
to fi x to the cable an IEC angle plug. The plug is in the
scope of delivery of the connection cable HDK 80.
• To connect the BAS 60 and the receiver, the cable is
to be plugged to the „IF IN" at the rear of the recei-
ver.
8. Adjusting the satellite receiver
• For TV sets with Scart connector:
Connect the TV set and the satellite receiver with the aid of the Audio/Video cable. Select on your TV set the
program position „AV".
Note:
• The digital receivers UFS 601si, UFD 170 and UFS 740sw are designed for connection to TV sets with a Scart
connector.
• Switch the basic setting of the receiver from „22 kHz" to the position „High/Low".
• Detailed information for modifying the basic setting is found in the operating instructions for the receivers.
• For tuning the satellite receiver, select the desired program.
The satellite receiver is pre-programmed at the factory (see the program table of the satellite receiver).
Braiding overturned
Rear panel Receiver example (Partial view)
Fig. 8
sleeve (optional)
Fig. 7