Audio-Technica ATW-3110a Installation Und Betrieb Seite 13

WIRELESS ESSENTIALS™ MICROPHONES AND CABLES
All Wireless Essentials accessories are terminated for use with ATW-T310 and other
UniPak™ transmitters.
AT829cW Miniature cardioid condenser lavalier microphone.
Includes clothing clip and windscreen.
MT830cW Miniature omni directional condenser lavalier
microphone. Includes clothing clip and windscreen.
MT830cW-TH "Theater" model, same as MT830cW except beige color
mic and cable for concealment.
AT831cW Miniature cardioid condenser lavalier microphone.
Includes clothing clip and windscreen.
AT851cW Surface-mount wide-range hemi-cardioid condenser microphone.
AT857AMLcW 19" gooseneck cardioid microphone.
Mounts to 5/8"-27 thread. Includes windscreen.
AT889cW Headworn noise-canceling condenser microphone.
Includes windscreen and cable clip.
AT892cW Microset single earmount 2.5mm (omni or cardioid)
micro headset.
AT898cW Subminiature cardioid condenser lavalier microphone.
Includes clothing clip base, viper clip base, magnet clip base,
three single mic holders, two double mic holders and
two windscreens.
AT899cW Subminiature omnidirectional condenser lavalier microphone.
Includes AT899AK accessory kit.
AT899cW-TH "Theater" model, same as AT899cW except beige color mic
and cable concealment. Includes AT899AK-TH accessory kit.
ATM35cW Cardioid condenser instrument microphone.
Includes AT8418 clip-on instrument mount.
ATM73cW Headworn cardioid condenser microphone. Includes windscreen.
ATM75cW Headworn cardioid condenser microphone. Includes windscreen.
PRO8HEcW Headworn hypercardioid dynamic microphone.
Includes windscreen and cable clip.
PRO35xcW Cardioid condenser instrument microphone.
Includes AT8418 clip-on instrument mount.
AT-GCW Hi-Z instrument/guitar cable with 1/4" phone plug.
XLRW Connecting cable for UniPak transmitter with an XLRF-type
input connector, for Lo-Z microphones with XLRM-type
output terminations.
Optional System Accessories
RECEIVER ACCESSORIES
AEW-DA-860UK UHF (840–865 MHz) active unity-gain antenna distribution
AEW-DA800EU Same as AEW-DA860UK except for 795-820 MHz operation.
AT8630
ATW-A20
ATW-A49
ATW-RA1
RF Cables
TRANSMITTER ACCESSORIES
AT8114
AT8141
AT8390
AT8456a
13
system provides two "1-in, 4-out" RF channels; connects a
pair of antennas to as many as four diversity receivers;
cascade output provided as a directional coupler. AC pass-
through allows daisy-chain AC hookup. Defeatable antenna
power. Metal receiver chassis with reinforced mounting ears
and rear rack mount capability. Includes detachable IEC
power cable, IEC pass-through cable, ten RF cables, front-
mount antenna cables and connectors, four DC power
cables to power up to four 3000 Series receivers. Mounts in
a single 19" rack space. For use with ATW-R3100UK Band receivers.
For use with ATW-R3100a Band EX receivers
Joining-plate kit allows rack-mounting two ATW-R3100
receivers side-by-side in a single (1U) 19" rack space.
Pair of UHF ground-plane antennas with 5/8"-27 thread for
mounting to microphone stands, etc. For use with
ATW-R3100a (Band UK or Band EX) receivers. Takes RF cables with
BNC connectors, not included; see RF Cables below.
Pair of UHF wide-band directional LPDA (log periodic dipole
array) antennas provide enhanced signal pickup for UHF
wireless systems throughout a wide band range
(440-900 MHz). Each antenna paddle is matched to 50 ohms
impedance with intergral high-quality low-loss BNC
connector; 6 dB gain. For permanent or temporary
installation; mounts to 5/8"-27 threads.
Rack-mount antenna kit brings antenna inputs to the front of
receiver for ease of setup, or when receiver is enclosed in a
metal rack. Includes a pair of extendible antennas. NOTE:
Two adapter kits are required when mounting two receivers
side-by-side in a single 19" rack space.
Low-loss design, 50 ohm impedance, with BNC-to-BNC
connectors:
AC12 RG58-type cable (12')
AC25 RG8-type cable (25')
AC50 RG8-type cable (50')
AC100 RG8-type cable (100')
Foam windscreen for handheld transmitter.
Water-resistant pouch for UniPak transmitter.
Shielded audio cable with 1/4" to 1/4" phone plugs.
Available in a variety of lengths.
(Also available with one straight and one 90° phone plug
as the AT8316.)
Quiet-Flex™ stand clamp for handheld transmitter, 5/8"-27 threads.
E
N