Specifications - Audio-Technica ATW-3110a Installation Und Betrieb

Overall System
UHF Operating Frequency
Band UK:
Band EX:
Number of Channels
Frequency Stability
Modulation Mode
Normal Deviation
Operating Range
Operating Temperature Range
Frequency Response
ATW-R3100 Receiver
Receiving System
Image Rejection
Signal-to-noise Ratio
E
Total Harmonic Distortion
N
Sensitivity
Intermediate Frequency
Audio Output
Unbalanced:
Balanced:
Output Connectors
Unbalanced:
Balanced:
Power Supply
Dimensions
Weight
Accessories Included

Specifications†

840.125 to 864.875MHz
795.500 to 820.000MHz
UK: 198 - 197 EX band
±0.005%, Phase Lock Loop frequency control
FM
±10 kHz
300' typical
41° F (5° C) to 113° F (45° C)
70 Hz to 15 kHz
Dual independent receivers, automatic-
switching diversity
60 dB nominal, 55 dB minimum
110 dB at 35 kHz deviation
(IEC-weighted), maximum modulation 75 kHz
≤1% (10 kHz deviation at 1 kHz)
24 dBµV (S/N 60 dB at 5 kHz deviation,
IEC-weighted)
243.950 MHz, 10.7 MHz
50 mV (at 1 kHz, ±5 kHz deviation,
10k ohm load)
32 mV (at 1 kHz, ±5 kHz deviation,
10k ohm load)
1/4" TS ("mono") phone jack
XLRM-type
PS6 230/240V AC 50Hz with supplied
13.5V, 500 mA AC adapter
8.27" (210.0 mm) W x 1.93" (49.0 mm) H
x 6.93" (176.0 mm) D
2.4 lbs (1.1 kg)
PS6 230/240V AC 50 Hz 13.5V,
500 mA AC adapter; two flexible UHF
antennas; rack-mount adapters
ATW-T310 UniPak™ Transmitter
RF Power Output
Spurious Emissions
Dynamic Range
Input Connections
Antenna Tip Color
Band UK:
Band EX:
Batteries (not included)
Current Consumption
Battery Life
Dimensions
Net Weight (without batteries)
If accessing de-reglated band 863.125 - 864.875 Mhz then RF power should be assigned to "RF Low". Some EU
countries may restrict both handheld and bodyworn RF devices to RF Low. Typically handheld devices should be
assigned "RF Low" and bodypack devices either "RF High or Low". If in doubt please check with your dealer or local
RF authority.
ATW-T341 Handheld Transmitter
RF Power Output
Spurious Emissions
Dynamic Range
Microphone Element
Batteries (not included)
Current Consumption
Battery Life
Dimensions
Net Weight (without batteries)
Accessory Included
† In the interest of standards development, A.T.U.S. offers full details on its test methods to
other industry professionals on request.
Specifications are subject to change without notice.
12
High: 30 mW; Low: 10 mW, nominal
According to R&TTE Directive
110 dB, A-weighted
High impedance, low impedance, bias
Grey
Black
Two 1.5V AA alkaline
High: 190mA; Low: 160mA, typical
Approximately 6 hours (High); 8 hours
(Low), depending on battery type and
use pattern
2.60" (66.0 mm) W x 3.43" (87.0 mm) H
x 0.94" (24.0 mm) D
2.8 oz (80 grams)
10 mW, nominal
According to R&TTE Directive
110 dB, A-weighted
Dynamic cardioid (unidirectional)
Two 1.5V AA alkaline
160mA typical
Approximately 6 hours depending on battery type
and use pattern
9.33" (237.0 mm) long, 1.89" (48.0 mm)
diameter
9.9 oz (280 grams)
AT8456a Quiet-Flex™ stand clamp