Troubleshooting; Maintenance - Beper 50.910 Betriebsanleitung

Rechargeable vacuum cleaner Use instructions
TROUBLE SHOOTING
If your vacuum cleaner is not functioning properly before making any checks, slide the switch on/off
switch to the off position (O).
PROBLEM
Your vacuum does
not start.
Your vacuum starts
but switches off after
a few seconds.
The vacuum does not
suck.
The vacuum has lost
suction power, is noi-
sier or whistles.
The vacuum is diffi-
cult to move
CAUSE
The unit is not charged.
Badly connected cable to unit
or mains.
Mains socket not working.
The suction nozzle or hole (10)
is partially blocked.
The filter assembly (15) is blo-
cked.
Dirt on the multi-purpose brush
(22) is preventing it from rota-
ting.
The motor for the multi-purpo-
se brush (22) has overheated
due to tangled waste.
The suction nozzle or hole (10)
is partially blocked
The dust container (11) is full.
The dust container (11) is not
fitted correctly.
The suction head (20) is dirty.
The foam motor protection fil-
ter (16) is saturated.
Suction power is too high.
Rear wheels are dirty.
SOLUTION
Recharge the batteries.
Connect the cable correctly to the unit
and the charger to the mains supply.
Contact an electrician to have it repai-
red.
Remove the dirt blocking the suction
nozzle.
Follow the CLEANING & MAINTENAN-
CE instructions.
Follow the CLEANING & MAINTENAN-
CE instructions.
Slide the On/Off switch to the "O" posi-
tion. Allow the unit to cool down. Follow
the instructions for cleaning the multi-
purpose brush described in the CLEA-
NING & MAINTENANCE section.
Remove the dirt blocking the suction
nozzle.
Empty it as described in CLEANING &

MAINTENANCE

Fit it correctly.
Follow the CLEANING & MAINTENAN-
CE instructions.
Follow the CLEANING & MAINTENAN-
CE instructions.
Reduce the suction power.
Clean the rear wheels.
20