General Guidelines - Velleman VTSS4NSET Bedienungsanleitung

3.

General Guidelines

•
Refer to the Velleman® Service and Quality Warranty on the last pages of this
manual.
•
All modifications of the device are forbidden for safety reasons. Damage caused by
user modifications to the device is not covered by the warranty.
•
Only use the device for its intended purpose. Using the device in an unauthorised
way will void the warranty.
•
Damage caused by disregard of certain guidelines in this manual is not covered by
the warranty and the dealer will not accept responsibility for any ensuing defects or
problems.
•
Nor Velleman nv nor its dealers can be held responsible for any damage
(extraordinary, incidental or indirect) – of any nature (financial, physical...) arising
from the possession, use or failure of this product.
•
Keep this manual for future reference.
4. Overview
Refer to the illustrations on page 2 of this manual.
1
2
3
4
5. Instructions
5.1 Preparation
•
Put the soldering iron holder in the corresponding hole in the casing of the soldering
station.
•
Make sure the sponge is completely saturated with clean water and let it drip off
before you put it in the sponge tray.
•
Put the soldering tip into the shaft and attach it to the soldering iron with a coupling
nut. Only change a soldering tip when the soldering iron has cooled down. Loosen
the coupling nut and gently pull out the soldering tip. Check the screw fitting
regularly and tighten it when necessary.
WARNING! - Never use the soldering iron without the soldering tip.
V. 02 – 05/07/2019
on-off switch
temperature control
sponge
iron stand
VTSS4NSET
5
6
7
8
6
bit
heating element
antiskid rubber
handle
©Velleman nv