English; Important Warnings - Nilfisk-Advance Nilfisk compact Bedienungsanleitung

ENGLISH

Instruction for use
Before using the vacuum cleaner make sure that the
voltage shown on the rating plate underneath the
vacuum cleaner corresponds with the mains voltage.
The vacuum cleaner is supplied with a paper dust
bag already in place. Never use the vacuum cleaner
without a properly fitted dust bag and a main filter.
The procedure for replacing the dust bag is described
under point 6.

IMPORTANT WARNINGS

1. This machine is not suitable for picking up health
endangering dust.
2. This machine is for dry use only and shall not be
used or stored outdoors in wet conditions. Store
indoors between max. 60∞ (degrees centigrade)
and min 0∞ (degrees centigrade).
3. The machine for vacuuming dry dust must not be
used for the suction of water or other liquids.
4. The machine must not be used for picking up com-
bustible or explosive materials, nor should it be
used in an explosive atmosphere.
5. The machine should under no circumstances be
used for picking up hot material. In particular the
machine must not be used for cleaning open and
closed fireplaces, ovens or similar that contain
warm or glowing ashes.
6. The machine must not be used if the electrical cord
shows any sign of damage. Regularly inspect the
cord for damage, in particular if it has been crus-
hed, shut in a door or run over.
7. Hold plug when rewinding onto cord reel. Do not
allow plug to whip when rewinding.
8. The machine must not be used if it is faulty.
9. Do not unplug by pulling on cord. To unplug, grasp
the plug, not the cord.
10. When repairing or replacing the cord, the same
type of cord as originally supplied with the machi-
ne must be used. This cord can be supplied by
NILFISK.
11. The plug must always be removed from the socket
outlet before starting any service work on the
machine or the cord.
12. Only a skilled or instructed person can repair the
electrical unit such as motor or the cord after
having disconnected the plug.
13. No changes or modifications to the mechanical or
electrical safety devices should be made.
14. The maximum airborne noise (sound pressure
level) is below 70 dB(A)/20µ Pa.
Compact brugsvejl ALLE Sprog 17
1. Starting /Stopping
Hold the plug and draw the cable all the way out of
the vacuum cleaner. On the cord, there is a red and a
yellow sign for full exposure of cord.
Plug the cable into the wall socket.
Switch the vacuum cleaner on by pressing the on/off
button.
Models with two speed regulation
The motor has two power settings - high power and
low power.
The motor will start under whatever power setting was
in effect the last time the vacuum cleaner was in use.
You can cycle between high suction and low suction
by repeatedly pressing the two-speed button.
2. Connecting the hose and tube
Insert the hose connector into the inlet port and turn
it clockwise until it engages. To remove the hose, turn
counterclockwise. Connect the hose to the tube and
nozzle by pressing the parts together.
Models with telescopic tube
The telescopic tube can be adjusted to your height.
Hold the central area with one hand while pulling the
smallest tube out or pushing it into the desired length
with the other hand.
3. Fitting the parking bracket to the brush
If the parking clip falls of, it can easily be repositio-
ned.
Place the parking bracket on the proper position of
floor brush. Then press the parking bracket into place
on the sleeve by pressing hard.
4. Parking the tube and nozzle
There are two places for parking on this vacuum clea-
ner.
One located between the buttons, and the other on
the bottom side. Turn the nozzle so that the suction
surface on the nozzle is facing away from the machine
to avoid scratching the sidewall, and press the parking
bracket - fitted on the nozzle - down into the recess
in the hole between the buttons.
If the vacuum cleaner is standing on its end, you can
park the nozzle on the bottom side in the same way.
17
05/01/05, 13:02:23