Product Operation - Zoef Robot Bep BP200Z Gebrauchsanweisung

Product Operation

3
3.1 Quick start guide
① Put the home base in place, and connect the adapter. The indicator light on the home base will be
normally on. Put the home base along a wall, and remove all barriers respectively 1m on the left and right
and 2m in front of it, as shown below.
② Open the power switch at the bottom of the machine. The button on the machine turns green and will be
normally on.
(If you don't operate the machine within 10 minutes, the machine will enter dormancy mode).
Note：
Please make sure that the power switch has been turned on. Otherwise, the machine will be unable to operate and be
charged.
If the machine is red and give alarm sound when being charged. It indicates that the bottom power of machine has not
been turned on, thus the machine cannot be normally charged.
Please make sure that the power switch is in open state before charging. Otherwise, the machine will be unable to be
e ectively charged.
③ The machine can be charged via the following ways:
A. Plug the power adapter in the home base and connect the other side with power supply, as shown in Fig: A.
B. Under standby or cleaning status, press automatic re-charging button on the remote controlto make
the machine go back to the home base for charging, as shown in Fig: B.
C. Under standby or cleaning mode, press the go home
To better prolong life of the battery:
A. The rst three times the new battery charge is more than 24 hours.
B. When the machine is normally used, please store the battery on home base and ensure that the home base is
connected to power.
C. If the machine won't be used for a long time, please fully charge the machine, turn o the power switch, take the
battery out and store it in ventilated and dry places.
④ Automatic charging
When the battery power is too low, the machine can automatically seek home base for charging.
button in the machine to enter the go home mode.
EN-5