Record-Peak: Recording The Peak Value Peak Max (1 Ms) - Chauvin Arnoux F 25 Bedienungsanleitung

By successive presses on the MAX/MIN button you access reading of the MAX, MIN,
AVG (HOLD is steady on display) and the current digital value (HOLD flashes).
NB: Press the MAX/MIN button again and HOLD is again steady: you access the cur-
rent digital value frozen when HOLD was pressed; the recording is still tempora-
rily paused.
Press HOLD again and the recording restarts: HOLD and PAUSE disappear. The values
previously recorded are saved.
NB: PAUSE with clock
If the time and date configuration is selected, pause freezes the AVG time value but does
not stop the date and time (see figure B).
Figure B: Time and date on the secondary display
MAX
e.g. the time since entering RECORD mode is 1 hour 59 minutes. The recording has
been paused (HOLD - RECORD - PAUSE) for 7 minutes.
RECORD-PEAK: Recording the PEAK-MAX value ( 1ms)
On peak value measurement, current A PEAK or voltage V PEAK, it is possible to access the
RECORD mode but only for the MAX value. The access, read and stop procedure is identical
to that of RECORD mode.
RECORD: current PEAK (³ 1ms)
The PEAK-MAX value corresponds to the largest sample found, positive or negative (sample
1ms).
The and
values (see PEAK chapter - figures A, B, C).
MIN
Steady
PEAK MAX (³ 1ms)
buttons allow you to identify the MAX-PEAK "+" and MAX-PEAK "-"
AVG
5 1
Time elapsed
Flashing
current PEAK (³ 1ms)