FLAEM Rhino Clear Mobile P0907EM Bedienungsanleitung Seite 15

Storage: Store sterilized components as per instructions of the sterile barrier package or system chosen.
3.7 - INLET VALVE. The nasal irrigator features a inlet valve (5c) which should
be cleaned when dirty; it is housed under the lid located on the bottom
of the irrigator compressor body (FIG. G). To clean the valve first remove
the lid (by levering with a biro and holding down the other side of the lid)
and then the valve; finally wash the valve in water and detergent. Before
reassembling, make sure that the valve is completely dry.
ADDITIONAL CLEANING INFORMATION of the atomization chamber (with the exception of the
compressor body)
In order to avoid deposits that may clog the atomizer and the atomization chamber and consequently affect the operation of
the nasal irrigator, it is recommended that cleaning and sanitizing is performed after each use following the instructions for use
contained in this instruction manual included with the nasal irrigator.
After rinsing accurately the parts under warm tap water (40°C approx.), shake the wet parts vigorously in order to eliminate any
remaining droplets of water. Then, place the parts on a paper towel or dry them using a jet of warm air.
WARNING: Should your nasal irrigator not atomize properly after cleaning and sanitizing is performed, do not use sharp tools
(i.e. screwdrivers, scissors ends, needles, hairpins, etc.) to try to clean or unclog the atomizer or atomization chamber holes as
this could damage these parts and impair the correct operation of the unit. Instead, perform additional cleaning and sanitizing
cycles as described in the instruction manual and above recommended, until the nasal irrigator starts to operate properly again.
4. Important cautionary notes
Like all electrical appliances, especially where children are concerned, Rhino Clear Mobile requires a number of
basic precautions.
4.0 - This M.D. is also intended for direct use by the patient.
4.1- Before using the device for the first time and periodically during the product's life, check the integrity of its
structure and of the power cable, making sure that there is no damage; if it is damaged, do not insert the
plug and take the product immediately to an authorised technical assistance centre or to your local dealer.
4.2 - Do not allow the nasal irrigator to be used as a toy. Careful attention is necessary when used by or near
children.
4.3 - Children and disabled persons should always use the nasal irrigator under strict supervision of an adult who
has read this manual.
4.4 - Some components of the device are small enough to be swallowed by children and can cause suffocation;
store the device out of the reach of children.
4.5 - Never use adaptors for power supplies different from the one indicated on the recharger base of the nasal
irrigator (plate details). Keep the cord away from heated surfaces
4.6 - Keep the power supply cord away from animals (for example rodents) as they may damage the insulation of
the power supply cord.
4.7 - The unit should not be used in the presence of inflammable anaesthetic mixtures containing oxygen or
nitrous oxide.
4.8 - Do not handle the recharger base plug with wet hands. Never submerge the recharger base in water;
should this occur accidentally, unplug it immediately. Do not touch the unit under water before pulling out
the plug. Take the unit immediately to an authorised service centre or your dealer.
4.9 - Never wash the irrigator compressor body under running water or by soaking. Do not use the nasal irrigator
when taking a bath or shower.
4.10 - Repairs may only be performed by authorised personnel, following the information in the restricted area of
13
FIG. G
5c