CO/Tech NTH22-18ARB Original Bedienungsanleitung Seite 6

Display
20. Button lock
21. Timer
22. AI function – the fan speed
adapts to the temperature
23. Fresh air (low)
24. Fresh air (high)
25. Sweeping motion
26. Set (desired) room temperature
27. Hours – shown with timer setting
28. Hot air 1200, 2050 and 2200 W
Instructions for use
Placement
• The fan heater should be placed on a hard, level and stable surface that is capable
of supporting its weight.
• Never place the fan heater on soft surfaces such as beds, blankets or thick rugs.
• Do not place the fan heater in a bathroom, laundry room, or close to a bath or shower.
• Do not use the fan heater in damp or very dusty environments.
• Fire hazard. Flammable materials such as furniture, paper, clothes and curtains
must be placed at least 50 cm above, behind and to the side of the heater, and
a minimum of 120 cm in front of it.
On/off
1. Remove the battery cover from the back of the remote control and insert 2 × AAA/
LR03 batteries (sold separately). Refer to the markings in the battery compartment
to ensure correct polarity. Never mix old and new batteries. Never mix
rechargeable and non-rechargeable batteries.
2. Refit the battery cover.
3. Plug the mains lead into a wall socket.
4. Switch on the power switch (6).
5. Press [ ] on the control panel or the remote control.
6. Press [ ] repeatedly to select the function as per Product description.
7. Press [ ] to switch off.
If the fan heater has been running in any of the heat modes, it will move over to
fresh air mode for 15 seconds before switching off (cooling function).
20
21
22
23
6
26
27
28
24 25