Technibel GRFX123R5I Bedienungsanleitung Und Installationsanleitungen Seite 24

REMOTE CONTROL FUNCTIONS
Note: make sure there are no obstacles between the remote control and the receiver;
Do not drop the remote control. Do not spill liquids on to the remote control, do not expose the remote control to
direct sunlight and keep it away from heat.
REMOTE CONTROL
ON/OFF
ON/OFF BUTTON
Press this button to switch the unit on or off.
At switch off even the night program SLEEP
will be deactivated.
MODE
MODE BUTTON
Press this button to select the function mode:
Auto, Cooling, Dehumidi cation, Ventilation
only, Heating.
In Auto function mode, the temperature is not
displayed
AUTO
COOLING
DEHUMIDIFICATION
VENTILATION ONLY
HEATING
23
Signal transmitter
SLEEP
SLEEP BUTTON
Press this button to activate or deactivate the
night SLEEP function. At switch on, the SLEEP
program is not active. When switching off the
appliance, the SLEEP program is deactivated.
After setting the SLEEP program the following
icon
control This program cannot be activated
with the Ventilation only and Auto function
modes.
FAN
FAN BUTTON
Press this button to select the fan speed AUTO,
Minimum, Medium, Maximum. Selecting
AUTO the fan sped is chosen by the unit.
CLOCK
CLOCK BUTTON
Pressing the icon
5 seconds. During ashing it is possible to
adjust the time acting on the buttons + or - .
Each press of the button + (-) corresponds to
the increase (decrease) of 1minute. Holding
the button +(-) the increase (decrease) will
be of 10 minutes in 10 minutes until the
button is released. To con rm the time, press
the CLOCK button again during ashing or
wait 5 seconds from the last setting and the
icon will stop ashing. After replacing the
batteries, the time displayed will be 12:00.
If the number displayed is preceeded by the
icon
otherwise it will indicate the Timer settings..
TEMP
TEMP BUTTON
Press this button to display
(on the diplay of the indoor unit):
- Temperature set
- Inside temperature
- Outside temperature
available)
°C-°F: press simultaneously MODE and - keys to pass from one to the other.
will be displayed on the remote
AUTO
MEDIUM
MINIMUM
MAXIMUM
the display ashes for
the value indicates the actual time,
.
.
(function not