Medicura m255 Bedienungsanleitung Seite 18

Repeating the measurement
Switch the device off, then simply press the "START" push button to start
another measurement.
Wait at least three minutes before the next measurement.
Calling up stored results
With the appliance off, press the MEM key to start the memory data call-
up mode.
Each time the MEM key is pressed, the recorded measurements are
displayed.
If the voice function has been activated, the appliance will say the memory
position number and the values stored.
If no measurement has been recorded, "00" will appear on the display as
the memory position number and "0" will appear as the recorded value.
To cancel the saved data, press the MEM key and hold it pressed for about
3 seconds until the appliance emits three beeps.
The display will appear first as shown in fig. 4 and then as shown in fig.
5.
Figure 4 Figure 5
Battery installation or replacement
When the battery symbol appears on the display, this means that the
batteries must be replaced. Proceed following the instructions below.
Make certain that the device is turned off.
Remove the cover and insert 2x1,5V AAA alkaline batteries, according to
the polarity symbols shown in Figure 6. Replace the cover correctly.
If the device will not be used for an extended period of time, it is
recommended that you remove the batteries.
18 Figure 6