Materiel Electrique PER1CRCR022B Bedienungsanleitung Seite 30

4 - INSTALLATION
4.5) ATTACHING OR REMOVING THE CRONOTHERMOSTAT FROM ITS BASE
Attach the cable cover by inserting panel
G
special slot E in the base, then fasten it to the
B
catches F by pressing lightly.
To remove the cover, use a small screwdriver to
prize apart each catch F in turn.
F
E
30
D into
D
If the chronothermostat is programmed before it is fixed to the wall-
mounted base, it may happen that after installation the
(off or blinking) in the display does not correspond to the actual status of
the relay.
Within 1 minute (max) of the chronothermostat being fixed to the base,
the relay will be activated according to the
displayed.
In order to remove the chronothermostat from its wall-mounted base,
grip as shown in the diagram, then pull outwards from the left-hand
side.
Fix the chronothermostat on the
base, taking care to insert the
contacts correctly, then exert light
pressure until you hear the click of
the attachment hooks on the base.
indication
ON
(off or blinking) indication
ON