Technical Specifications - CTEK MXS 10 Bedienungsanleitung

CONNECT THE CHARGER TO A BATTERY
Comfort
Connect
–
+
+
CTEK COMFORT CONNECT – eyelet M6
Comfort
Connect
6 • EN
INFO
If the battery clamps are incorrectly con-
nected, the reverse polarity protection
will ensure that the battery and charger
are not damaged.
For batteries mounted inside a vehicle
1. Connect the red clamp to the battery's
positive pole.
2. Connect the black clamp to the vehicle chas-
sis remote from the fuel pipe and the battery.
3. Connect the charger to the wall socket
4. Disconnect the wall socket before discon-
necting the battery
5. Disconnect the black clamp before the red
clamp.
Some vehicles may have positively
–
earthed batteries.
1. Connect the black clamp to the battery's
negative pole.
2. Connect the red clamp to the vehicle chassis
remote from the fuel pipe and the battery.
3. Connect the charger to the wall socket
4. Disconnect the wall socket before discon-
necting the battery
5. Disconnect the red clamp before the black
clamp.

TECHNICAL SPECIFICATIONS

Charger model MXS 10
Model number 1046
Rated Voltage AC 220–240VAC, 50–60Hz
Charging voltage
14.4V,
AGM
Start voltage 2.0V
Charging current 10A max
1.0A rms (at full charging current)
Current, mains
<1Ah/month
Back current drain*
<4%
Ripple**
-20°C to +50°C, output power is reduced
Ambient
temperature automatically at high temperatures
Charger type Eight step, fully automatic charging cycle
Battery types All types of 12V lead-acid batteries
(WET, MF, Ca/Ca, AGM and GEL)
20―200Ah up to 300Ah for maintenance
Battery capacity
197 x 93 x 49mm (L x W x H)
dimensions
Insulation class IP65
Weight 0.8kg
*) Back current drain is the current that drains the battery if the charger is not connected
to the mains. CTEK chargers has a very low back current.
**) The quality of the charging voltage and charging current is very important. A high
current ripple heats up the battery which has an aging effect on the positive electrode.
High voltage ripple could harm other equipment that is connected to the battery. CTEK
battery chargers produce very clean voltage and current with low ripple.
14.7V, 15.8V, 13.6V
RECOND SUPPLY