Mounting Of The Hose - Faicom MC Gebrauchsanweisung

7 - MOUNTING OF THE HOSE (Models without hose)
7.1
7.2
7.3
7.4
7.5
The hose reels without hose are supplied with
the unloaded spring.
Use a hose with dimension and pressure characte-
ristics suitable for use, as described on the schedu-
les, according to the hose reel code.
7.1) Fix the hose reel to the bench. Take out the
access door by levering with a screwdriver.
7.2) Put the hose between the guide rollers, con-
nect it to the fitting which is inside the drum
and tighten by the suitable wrench.
7.3) Put the hose rubber stop at about 50 cm from
the opposite end of the hose.
7.4) Loosen the two screws on the spring side by a
10 mm wrench.
7.5) Insert an hex wrench of 14 mm into the hole of
the shaft.
Rotate the wrench anti-clockwise (+) and wind
the hose until when the hose rubber stop is in
contact with the rollers support.
7.6) Pre-load the spring while continuing to turn
anti-clockwise (+) the wrench for 1,5 turns,
hold in position and block the shaft by the two
screws.
7.7) Unwind the hose and rewind it completely, to
check if the hose reel works properly.
If the hose does not rewind or does not with-
draw completely, adjust the spring tension.
When complete, place the hose rubber stop at
the desired distance from the end of the hose.
DO NOT PUT YOUR HANDS INSIDE
THE HOSE REEL!
7.8) Mount again the side access door.
7.6
- 12 -
7.7