Purpose Of Use; Work Area Safety - Beta 1498/2A Gebrauchsanweisung

INSTRUCTIONS FOR USE ISTRUZIONI PER L'USO
ELECTRONIC MOTORCYCLE BATTERY CHARGER, 12V
OPERATING MANUAL AND INSTRUCTIONS FOR ELECTRONIC BATTERY CHARGER
MANUFACTURED BY:
BETA UTENSILI S.P.A. Via A. Volta 18, 20845, Sovico (MB) ITALY
Original documentation drawn up in ITALIAN.
CAUTION
Store the safety instructions with care and hand them over to the users.

PURPOSE OF USE

The electronic battery charger can be used for the following purposes:
• Charging and holding motorcycles with 12V batteries.
• Suitable for all types of lead acid batteries and lithium batteries (LiFePO4).
The portable car starter must not be used for the following operations:
• Use on any batteries other than 12V batteries.
• Use on frozen or non-rechargeable batteries.
• Use outside the technical specifications contained in the TECHNICAL DATA table.
• Use in humid or wet environments, or in bad weather.
• Use for any applications other than stated ones.

WORK AREA SAFETY

Do not operate the battery charger in environments containing potentially explosive atmospheres,
because sparks may be generated, which can ignite the dust or fumes.
Keep children and bystanders away from your workplace while operating the battery charger.
Distractions from other people can cause you to lose control over the battery charger during use.
Do not inhale any harmful gases that may be released by the battery of the vehicle while charging.
During connection operations, keep your face away from the battery of the vehicle. The battery
contains corrosive substances; in the event of accidental contact of acid with your skin or eyes, rinse
immediately with water and seek medical advice.
Never reverse polarity between the clamps of the device and the battery clips; reversed polarity can
cause explosions or damage to the vehicle, the device and people.
Always connect the output lead with red clamp (+) to the positive post of the battery, and the output
lead with black clamp (-) to the vehicle's chassis.
Never bring the terminals of the device into direct or indirect contact (e.g. through metal connections).
Do not place the device on the battery while charging.
Do not drop any metal tools on the battery of the vehicle: the battery may short-circuit.
Use the battery charger in a dry area, avoiding humidity.
8
IMPORTANT! READ THIS MANUAL CAREFULLY BEFORE USING THE
DEVICE. FAILURE TO COMPLY WITH THE SAFETY STANDARDS AND
OPERATING PROCEDURES MAY RESULT IN SERIOUS INJURY.
EN I
ITEM 1498/2A