Percent Weighing; Scale Settings; Scale Increment; Backlight - OHAUS EB3 Bedienungsanleitung

EN-10 EB SERIES
4.9

Percent Weighing

Place the reference item on the pan (ex. 300g) then press %.
"100.00%" will be displayed.
The weight of any item subsequently placed on the pan will
be displayed as a percentage (ex. 600g will be displayed as
200%) of the originally established reference weight.
NOTES:
• It is normal for small weight changes to be displayed as large decimal
increments in %.
To exit Percent Mode, press Exit .
•

5. SCALE SETTINGS

• Press then release COUNT and M+ at the same time to enter into the user-
selectable scale settings (Setup mode).
In Setup mode:
o Press
o Press Enter to accept the displayed setting and proceed to the next
parameter
Press Exit to proceed to the next parameter without saving any
o
changes
• Re-start the scale after changing settings in the Setup mode.
The following parameters are available (illustrated displays reflect default settings):
5.1

Scale Increment

Sets the displayed scale increment (also known as readability
or graduation). Selectable setup values will be model
dependent and are equivalent to within 30,000 to 3,000 scale
divisions.
5.2

Backlight

Sets the activation mode of the backlight.
The following settings are available: AU (Auto-on with items
greater than 9d placed on the pan or any key is pressed; turns
off after 5 seconds of inactivity), on, oFF.
5.3

Zero Tracking Range

Sets the range in which the zero reading is maintained.
The following settings are available: 0.5d, 1d, 2d, 4d (d =
scale division)
5.4

Filtering

Sets the level in which the Stable indication turns on; the higher
the setting, the faster the stabilization time.
The following settings are available: 0, 1, 2, 3 (levels)
to step through available settings