Sthor 82951 Handbuch Seite 9

GB
Pressing the both buttons of lock, disconnect the tank from the device (II). Pull out the internal filter (III) using the external filter
bow (IV). During the filters installation you should pay special attention to the correct installation of external filter. Filter holders
must fit to tank guides and the flange of the front filter has to be adapted to the inlet of tank (V). Only correct installation will ensure
proper operation and prevent damage to the vacuum cleaner. The bow of external filter should be folded up towards the tank top,
and then the internal filter (VI) should be slid. Attach the tank with mounted filters to the body of the vacuum cleaner so that the
both latches secure connection.
Vacuum cleaner can operate without adding accessories, as well as with their use. The hose can be connected by inserting the tip
of smaller diameter to tank inlet (VII). Connect the suction nozzle to the free end of the hose by inserting it into the hose connec-
tion. Both hose connections ensure free revolution, which further improves ergonomics of the vacuum cleaner.
The tip equipped with a brush is used for cleaning surfaces that can be subject for easy scratching. Narrow tip is used for cleaning
hard to reach places.
Operation of the vacuum cleaner
NOTE! It is prohibited to work with a vacuum cleaner with hot ash. Temperature of the sucked waste by the vacuum cleaner may
not exceed 40 °C.
Make sure that all the preparatory activities have been properly performed.
Make sure that the vacuum switch is on the off position "O".
Insert the plug of power cord into socket of power supply installation, the LED on plug lights up, then shift the switch to position
on "I" (VIII).
After finishing work switch off the vacuum cleaner with the switch and then unplug the power cord from the mains socket. Proceed
to the maintenance activities for vacuum cleaner.
If, after you connect plug the LED does not light up, and the vacuum cleaner will not run it may mean burning a fuse in the plug.
In this case It should be replaced. For this purpose, unscrew the mounting ring (IX). Remove the plug contact and fuse. Perform
installation in reverse order (X).
Note! If during the operation there will be observed suspicious vibration, drop in suction, or you will hear the louder engine opera-
tion, it may mean the filling of tank or clog of hose or suction nozzle. In this case, immediately turn off the vacuum cleaner by the
switch and unplug the power cord from the mains socket. Then empty the tank and check for obstruction in the hose and nozzle. If
necessary unblock. if unblocking the hose or suction nozzle is not be possible, they must be replaced before further work.
Maintenance of the vacuum cleaner
Note! Before any maintenance activities, make sure that the power cord is disconnected from the mains socket.
After each use of a vacuum cleaner, check the tank lid seal, and air filter as it is described in the Section: "Preparing for opera-
tion".
Clean the vacuum from the outside with a jet of compressed air, of pressure of not more than 0.3 MPa. Particular attention should
be paid to the patency of the ventilation holes, both inlet and exhaust. If needed, clean it by compressed air of pressure not more
than 0.3 MPa. Do not use sharp metal objects to clean the vents. Do not immerse the cleaner in water to vacuum clean it. Vacuum
cleaner hose must be checked before and after each use for damage. It is forbidden to use a damaged hose.
Larger dirt from the housing should be removed with a soft cloth.
O R I G I N A L I N S T R U C T I O N S
9